Customer login

 
Categories
All Products
. Support
. . Traxxas Support

Traxxas Support on YouTube

Please click HERE to see a number of great videos covering all key support areas for Traxxas products.

For support on Traxxas products, please visit Traxxas.com/Support

 

Getting Started: Basics of Driving Video:

https://traxxas.com/support/video#/?playlistId=0&videoId=0

 

Traxxas charger issues (charger included with model):

https://traxxas.com/support/video#/?playlistId=0&videoId=1

 

Blinking Red Light on your Speed Controller (ESC) / changing mode on your speed controller:

https://traxxas.com/support/video#/?playlistId=0&videoId=2

 

Traxxas transmitter stopped or not controlling your car. How to Bind a Traxxas Transmitter and Receiver:

https://traxxas.com/support/video#/?playlistId=0&videoId=3

 

TQ 2.4GHz Transmitter Reset (single button transmitters only)

  1. Start with the controller turned off. Make sure it has fresh batteries in it.
  2. Hold down the red SET BUTTON and continue to hold it while turning on the transmitter. Do not let go of the button yet.
  3. Continue holding the red SET BUTTON for about 10 seconds. During this time, the transmitter status light will be blinking red
  4. After 10 seconds, the transmitter status light will change to blinking green. NOW you can let go of the button. But wait! There's more!
  5. Turn the controller steering wheel all the way LEFT, hold it there and press the red SET BUTTON once. The status light will blink green faster than it did before. Let go of the steering wheel so it can go back to center position.
  6. Turn the controller steering wheel all the way RIGHT, hold it there and press the red SET BUTTON once. The status light will blink red slowly. Let go of the steering wheel so it can go back to center position.
  7. Squeeze the throttle trigger for FORWARD, hold it there and press the red SET BUTTON once. The status light will blink red faster than it did before.
  8. Push the throttle trigger for REVERSE, hold it there and press the red SET BUTTON once. The light will now change to SOLID GREEN - YOU ARE DONE!

 

TQi Tx Calibration 2/3 channel

  1. Press and hold MENU & SET buttons while turning the transmitter ON.
  2. Release MENU & SET buttons.
  3. Press and hold MENU & SET buttons down again until Green Led comes on.
  4. Release MENU & SET buttons. (Green LED blinks slow)
  5. Turn wheel all the way "Left" then press SET. (Green LED blinks faster)
  6. Release wheel to Neutral position.
  7. Turn wheel all the way "Right" then press SET. (Red LED blinks slow)
  8. Release wheel to Neutral position.
  9. Pull trigger all the way "IN" (vehicle going forward) then press SET. (Red LED blinks faster)
  10. Release trigger to Neutral position.
  11. Pull trigger all the way "OUT" (vehicle going reverse) then press SET. (LED light solid Green)
  12. Release trigger to Neutral position.
  13. DONE.